![]() |
Advertisement |
|
Please visit our local sponsor: |
Please visit our local sponsor: |
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: May 2015
Location: Clayton NC
Posts: 460
![]() |
Wiring experts?
Any wiring harness pros out there?
I'm only getting 2.6 volts on the communication wires (3 tan/1 tan with a black stripe) on my 6L90 Trans TCM. It's stuck in limp mode (3rd gear) and throwing all kinds of trans DIC messages. I have test hung a known good TCM and it does the same thing. I traced and cleaned up all of the grounds that I could find. I have the harness half way pulled out to check for damage, but can't seem to find anything. Any suggestions or recommendations are welcome!!! Thanks! ![]() ![]() ![]() ![]() ![]()
__________________
"Only those who will risk going too far can possibly find out how far one can go." - T. S. Eliot Last edited by theheder; 11-21-2018 at 07:39 AM.. |
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: Apr 2010
Location: Raleigh
Posts: 282
![]() ![]() |
There appears to be several points of connectors. Something is potentially drawing down the voltage, so I would start disconnecting things to see if the voltage returns.
|
![]() |
![]() |
![]() |
Thread Tools | |
Display Modes | |
|
|
Advertisement |